6502 Cartridge Port - Revision history

Mr z: Protected "6502 Cartridge Port" ([edit=autoconfirmed] (indefinite) [move=autoconfirmed] (indefinite))

2010-12-04T07:44:28Z

Protected "6502 Cartridge Port" ([edit=autoconfirmed] (indefinite) [move=autoconfirmed] (indefinite))

Mr z at 17:36, 30 June 2006

2006-06-30T17:36:50Z

Mr z at 17:36, 30 June 2006

2006-06-30T17:36:38Z

New page

(this is a stub article)

The 6502 Cartridge Port interfaces to the 6502's address and data bus, as opposed to the CP-1610's bus. This cartridge port allows adding 6502-specific software such as [[Keyboard Microsoft BASIC|Microsoft BASIC]].

This cartridge port offers a 44-pin card edge, and requires the cartridge to have a female card-edge connector on it. This is the opposite of the regular [[Cartridge Port|Master Component Cartridge Port]], where the unit offers a female card-edge connector and the cartridge provides only a card edge.

This cartridge port is found on the rear side of the unit behind a plastic door. The complexity of construction associated with the 6502-specific cartridges indicates that Mattel likely did not intend for many packages to use this interface.

← Older revision		Revision as of 17:36, 30 June 2006
Line 1:		Line 1:
−	(this is a stub article)	+	<I>(this is a stub article)</I>

	The 6502 Cartridge Port interfaces to the 6502's address and data bus, as opposed to the CP-1610's bus. This cartridge port allows adding 6502-specific software such as [[Keyboard Microsoft BASIC\|Microsoft BASIC]].		The 6502 Cartridge Port interfaces to the 6502's address and data bus, as opposed to the CP-1610's bus. This cartridge port allows adding 6502-specific software such as [[Keyboard Microsoft BASIC\|Microsoft BASIC]].

← Older revision	Revision as of 07:44, 4 December 2010
(No difference)